Evido EAD-B2000 El manual del propietario descargar pdf (Pagina 11)

PAGE DESCRIPTION

● CONFIGURATION

● TASK TYPE

● RANGE

● MARK POSITION

● STATISTICS

● FLY TO

● GRAPHIC

● MOVING MAP

● PLAN

● INFORMATION

● USER TP

● NEAREST

The page system does not "wrap around". The end pages are the CONFIGURATION page and the

NEAREST page.

Beginning with the CONFIGURATION page

This page appears everytime the B2000 is powered up, with the

cursor on the screen contrast value. Pressing the +/- button

allows you to change the screen contrast immediately. The

screen drive is temperature compensated so this value should

not need adjusting in flight. Magnetic variation, finish line and

turnpoint arrival altitude can also be set on this page and the

polar values, units, start, turnpoint and finish types and radius

and GPS and B50 status can be read by moving the cursor to

the top of the page and changing CONFIGURATION 0 to

CONFIGURATION 1 which then accesses the DIAGNOSTICS

pages. Pressing the PAGE button returns to the normal screens.

The page selection in diagnostics mode is a little slow so be

patient but this mode is not used in flight. The Macready, Bugs

and Ballast settings are shown at the bottom of this page. The

lower right corner shows either "B50" or "loc" which indicates

the source of this data, either the B50 or by changing "B50" to

"loc" these values may be changed at will by the pilot

independent of the B50 data. This is useful for doing "what if"

calculations in the back seat of two seaters. There is also the

drift/zig-zag wind calculation selection.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Sin comentarios

Evido EAD-B2000 El manual del propietario Pagina 11