Evido EAD-B1000 Manual de usuario descargar pdf (Pagina 18)

TelVue HyperCaster

User Manual / v4.3 / July 2014

HyperCaster

is a registered trademark of TelVue Corporation 800-885-8886 / www.telvue.com

program name, date and time of scheduled broadcast, and a description from the

content metadata as in this example.

Click your browser’s Back button to return to the Dashboard.

Field Descriptions – Feed Section

• Feed – information about incoming feeds. If this installation supports more than one feed,

each feed is listed in its own section. Feed information includes the name of the IP stream as

used on your system.

• Now Capturing – the name and thumbnail of the content currently being captured. The time

the capture was scheduled to start and its runtime are displayed below the thumbnail. Both

the start time and runtime are shown in hours, minutes, and seconds (HH:MM:SS).

• Stop – to stop the current capture immediately, click the Stop button. A confirmation dialog

will pop up.

• Next Up – the name, thumbnail, start time, and runtime of the next program scheduled to

run in the next 24 hours.

Field Descriptions – Switch Section

Switch information is displayed only in systems configured with the TelVue video switch control

module. A switch connected to a TelVue server controls the path of data from a feed, through the

server, to an output.

The table of switch audio/video inputs and outputs is displayed at the bottom of the Dashboard. If the

switch has more than 8 inputs and outputs, a table shows the input route for each output.

• Switch –The switch output ports are listed down the left side. Their default names are OUT1,

OUT2, etc. You can rename them via Switch Configuration.

• Port Locked – The Port Locked column shows whether a switch port is locked or unlocked. If

you lock a switch port it will hold that switch route until you unlock it manually. Although the

switch ignores switch events while it is locked, it keeps track of any scheduled switch events.

When you unlock the switch, it restores the switch route it would be using if you had not

locked the switch.

Input Columns – The switch input columns are headed with IN1, IN2, etc. You can rename

them via Switch Configuration.

If breakaway is enabled, the letter A is shown in the audio input columns and the letter V is shown in

the (video) input columns. If breakaway is disabled, there is one column per input with the letters AV

showing the input-output route.

• Switch Operation - The switch input/output configuration you set in Switch Configuration is

known as the home path. The input for each switch output is called the home port. During

everyday operation, programming comes from an input feed, passes through the switch, and

goes to an output channel. If you have switched off the home port and want to keep that path,

go to the Switch section of the Dashboard and click on Lock for the output port you want to

lock.

• Switch Continuity - Some installations use the switch for continuity programming. For

example when nothing is scheduled for a channel they might switch to IN8, which is that

user’s bulletin board feed. This changes the pattern on the display of switch inputs and

outputs.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 102 103

Comentarios a estos manuales

Sin comentarios

Evido EAD-B1000 Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Evido EAD-B1000